I found these diagrams at mymopar.com
http://www.mymopar.com/downloads/1971/7 ... unnerA.JPG
http://www.mymopar.com/downloads/1971/7 ... unnerB.JPG
I have started rewiring with the harness that has the neutral safety switch, starter relay ground, what looks like the dryer pressure switch wire for the a/c (blue wire).
The diagram A above makes it look like this plug shares wiring with the wiper motor. The way they are grouped implies that anyway. The wiper motor is a different plug.
Also, If anyone would have any pictures of firewall wiring, routing, looms, ties etc., any good reference pics. I could use some help getting the routing back to normal or stock looking.
Thanks for any help!
wiring diagram
Moderator: Site Administrators
-
rthrbfishn
- Satellite Sebring (RH)
- Posts: 72
- Joined: Wed Nov 03, 2004 3:14 pm
- My Cars: 1971 GTX
- Location: NW
wiring diagram
1971 GTX 440
1967 Barracuda 383 Fmla S
1967 Barracuda 383 Fmla S
-
72RoadRunnerGTX
- GTX (RS)
- Posts: 594
- Joined: Wed Dec 27, 2006 6:44 pm
- My Cars: 1972 Road Runner/GTX
1972 Satellite Sebring
1972 Satellite Sebring(big block parts car) - Location: Seattle, Washington
Re: wiring diagram
On the firewall side, the wiper motor connector is separate from the (auto trans) neutral safety/back-up light switch and A/C blower motor connector. They are immediate neighbors at the bulkhead connector however. The dark blue A/C clutch/underpressure switch circuit wire is wrapped with the blower motor wire(green) but connects to cavity #20 in one of the other firewall side connectors.
