Post
by road chicken » Mon Jul 31, 2006 9:21 pm
SURE No Problem
To release the Knob.....
You HAVE to have access to the switch backside. On the backside there is a spring loaded pin onthe metal side. Depress that pin while pulling out onthe switch knob. The knob AND the triangular shaft will slide out.
Reverse to re-install.
Then you have to spin the nut off. Problem is nobody has the damn socket to fit it. unless you have a buddy with a mill that can make atool- most people just skin their knuckles using a needle nose pliers inthe slots.
4th generation B bodys- there is no substitute.
68 383, Street Demon 750, RPM top end,484/284/108 poo poo cam "-5 spd 4:10 SG, 4whl disk, Helwig Anti-Sway, Poly bushings,Firm Feel Box, HD Linkage, 1" t-bars, 7 leafs Springs