'73/74 underhood pics PLEASE!!

rav440 · Post by **rav440** » Sat Dec 22, 2007 9:16 am

73X · Post by **73X** » Sat Dec 22, 2007 9:17 pm

Hey Randy,

Did you have any problems with headers on your X. Tried to put some on mine and finally gave up. They kept hitting the coupler on steering column. If you put them on, what make did you get them for? The ones I bought were from a swap meet, they could have been for a truck or e body, no idea. Passenger side fit fine.

Dale

rav440 · Post by **rav440** » Mon Dec 24, 2007 8:14 am

73X wrote:Hey Randy,

Did you have any problems with headers on your X. Tried to put some on mine and finally gave up. They kept hitting the coupler on steering column. If you put them on, what make did you get them for? The ones I bought were from a swap meet, they could have been for a truck or e body, no idea. Passenger side fit fine.

Dale

DALE , im not sure what the headers were that were on it , but they didnt fit to bad they had a few dent mods but not bashed in if i remember correctly the coupler was an issue as im guessing it will be with any header .
when the time comes im going to go with FLOW TECH or HOOKER SUPER COMPs for a B body .
truck heads would be way longer and drop down to far on a car from what i understand .

Post by **Eric** » Mon Dec 24, 2007 9:05 am

Super comps will fit, but ground clearance will be low and because they're held close to the floor pans, watch your clearance to the speedometer cable (DAMHIK)

Hotwheelsjr · Post by **Hotwheelsjr** » Wed Dec 26, 2007 9:59 pm

Thanks to all who have posted the underhood pics...

I hope to have it running within the next couple of weeks!!