Under-dash shoddy pad

71Satellite98661 · Post by **71Satellite98661** » Thu Mar 27, 2014 11:20 pm

Does anyone have any pictures of how the shoddy pad insulation was installed originally? (1971). I am just about ready to install the heater and A/C box. Would you use something like 3M Super 77?

kenny · Post by **kenny** » Fri Mar 28, 2014 12:39 am

I sprayed the pad with 3m aerosol adhesive then installed it this is the only pic i have

[/quote]

Get your pad out and put it up under dash dry you will figure its position out i did have to trim a section off hope it helps

71Satellite98661 · Post by **71Satellite98661** » Fri Mar 28, 2014 12:59 am

Thanks Kenny. Nice job!

71Satellite98661 · Post by **71Satellite98661** » Fri Apr 04, 2014 12:05 am

Easier than I thought. I only sprayed the backside of the insulation and not the sheetmetal. The jute is somewhat stretchy and very easy to form around the contours of the firewall.

71Satellite98661 · Post by **71Satellite98661** » Fri Apr 04, 2014 12:06 am

Another shot...

71Satellite98661 · Post by **71Satellite98661** » Fri Apr 04, 2014 12:06 am

Close up...

71Satellite98661 · Post by **71Satellite98661** » Fri Apr 04, 2014 12:07 am

Another...

Road Runner Nest

Under-dash shoddy pad

Under-dash shoddy pad

Re: Under-dash shoddy pad

Re: Under-dash shoddy pad

Re: Under-dash shoddy pad

Re: Under-dash shoddy pad

Re: Under-dash shoddy pad

Re: Under-dash shoddy pad