What size tap for LCA bushing press out?
Posted: Mon Sep 24, 2018 8:21 pm
So after reading how the A-body guys do things, I bought a 1-3/8" tap to drive down the LCA outer shell (so I can press the bushing out) since I have a 30-ton press already. Stupid me, didn't even think that perhaps our LCA bushings are beefier. I tried measuring, but can't decide if I need a 1-7/16" tap, or a 1-1/2" tap? Anyone know?
Manual says to run an air chisel down them, but I don't have a compressor anymore, nor an air chisel.
Manual says to run an air chisel down them, but I don't have a compressor anymore, nor an air chisel.