Hood mounted turn signals

[rr6pak]

Does someone have a picture of the underside of the hood that shows how the wires for the hood mounted turn signals are attached to the hood? My clip is broke and need to see

Also, does the tubing for the windsheild squirters just run along the wire harness loom and come up ti the "tee" on the hood?

Thanks!

[rr6pak]

No one????

[Ronnman]

See attached thread below. If you need addition pics I can dget some, but give me some time because I just got my computer back from the repair shop.

http://www.roadrunnernest.com/forum/vie ... 416#p33416

[rr6pak]

See attached thread below. If you need addition pics I can dget some, but give me some time because I just got my computer back from the repair shop.

http://www.roadrunnernest.com/forum/vie ... 416#p33416

Thanks Ronman! The more picture, the better. I'd like to see the clip that holds the wires against the hood and how the wires connect to the harness, if you can get them. My body guy will be done with the old girl soon.

Thanks again

[Ronnman]

Here's a few more pics. I have new hood wiring clips but have not installed them as of yet.
Ron

[Ronnman]

Another of the wiring where connected to the harness.
Ron

[Ronnman]

Last one of wiring from turn signals and clip positions. Note one of the clips appears to have been installed in the wrong hole.
Ron

[rr6pak]

Ronman:

Where did you get the plastic clips from?

Again, thanks!

[Ronnman]

R/T Specialties 570-388-1082. Item number UNP
Ron

[Ronnman]

I see on R/T Specialties website it appears the number of the clips are 0876263 WIRE RETAINER HOOD TURN INDCTR, $1.00 each.
Ron

http://www.rtspecialties.net/products.asp?cat=13

[rr6pak]

Thanks a bunch! I think I need 2