Page 1 of 1
Holes in floor for bucket seats.
Posted: Fri Dec 30, 2011 7:13 am
by 71Beeper
Guys - does anyone have a photo of the floor where the bucket seat track holes are located?
I'm just about finished installing the new drivers side floor pan and since my car came with aftermarket seats when I bought it I think the original seat holes were plug welded and new holes drilled.
Re: Holes in floor for bucket seats.
Posted: Fri Dec 30, 2011 8:26 am
by farmboy70
Heres one for now ,I'll post a better shot tonight.
Dave
Re: Holes in floor for bucket seats.
Posted: Fri Dec 30, 2011 10:07 am
by farmboy70
Re: Holes in floor for bucket seats.
Posted: Fri Dec 30, 2011 10:12 am
by farmboy70
Center to center on the measurements.
Dave
Re: Holes in floor for bucket seats.
Posted: Fri Dec 30, 2011 11:54 am
by Eric
center hole braces welded to the floor plans....
Re: Holes in floor for bucket seats.
Posted: Sat Dec 31, 2011 12:18 am
by 71Beeper
Many Thanks to Dave and Eric for the very helpfull pictures!!!!
Re: Holes in floor for bucket seats.
Posted: Sat Dec 31, 2011 9:30 am
by farmboy70
This post reminded me I still have to weld the plates in on mine yet, Thanks
Dave
Re: Holes in floor for bucket seats.
Posted: Sat Dec 31, 2011 9:35 am
by farmboy70
Not to highjack but if anyone has good measurements of the console and shifter brackets for an auto car let me know.
My floor was hacked for a four speed and I have no location for these.
Thanks
Dave
