manifold gaskets?

Clone Runner · Post by **Clone Runner** » Tue Nov 17, 2009 11:11 pm

ok, i tore the top of the motor off to check the cam for wear, its fine, just wanted check previous owner installed it, when they put it together they went gasket, valley pan, gasket, manifold. is that correct? i'm new to big blocks.

RON71rr · Post by **RON71rr** » Wed Nov 18, 2009 12:00 am

Factory cast intakes used just the valley pan, no fiber gaskets. I like to use the fiber gaskets with the valley pan for aluminum intakes, some say it's not needed. Just my preference.

landon1 · Post by **landon1** » Wed Nov 18, 2009 12:52 am

i've never even seen the paper/fiber intake gaskets - i just use the valley pan with a little gasket sealer around the edges

Post by **bruce** » Wed Nov 18, 2009 9:32 am

landon1 wrote:i've never even seen the paper/fiber intake gaskets - i just use the valley pan with a little gasket sealer around the edges

That's what's on mine:

Road Runner Nest

manifold gaskets?

manifold gaskets?

Re: manifold gaskets?

Re: manifold gaskets?

Re: manifold gaskets?