Road Runner Nest

I have a 71rr which I replaced the pad and in the process of hooking everthing back up. The car came equipped with a 3sp wiper motor. The wiper switch was missing when I pulled the dash out, however I have a couple of old used ones. The harness has a connector for the: Brn-tr; Brn; Blue; Pink which plugs right in. However the other connector on the same wire stem (red and green) does not fit the switch I have.
The switch I have is part# 3488 766, or 23199; date code looks to be: 0843. I thought I pulled this switch from a 72 ssp. Do I have the proper year switch? can I make it work? On the switch, the prongs which do not line up are marked F1 and F2. If I break the connector which wire goes where? red to F2 or F1? Please

no it is a 72 up 3sp wiper motor.wiper switch

is green f2 red f1 for the 72

get a connector from a 72 73 74 b-body

Thank you for your answer! SO...will that switch work for my application? if I modify the two prong connector?
Thanks Dan

mopardan wrote:Thank you for your answer! SO...will that switch work for my application? if I modify the two prong connector?
Thanks Dan

yes but go to the 72 spp cut the connector out than it will plug it too it

Great news! Actually Im going to: Male plug- inch of wire- female plug the hook up so nothing orininal gets ruined.
The ssp unfortunately like so many cars which I have purchased parts from is long crushed. A LOT of good, minimal rust cars which I have picked parts from over the years have been crushed. Unfortunately so many salvage yard owners would rather take the quick bulk metal cash, than sell a $25 switch here, $30 wheel moulding there.
Anyway, thanks for the info and y'all have a fine day!!

How about get a NEW switch for your application? You can get them for $25 on up