Road Runner Nest

Posted: **Tue Jun 19, 2007 5:58 pm**

Question for the guys with air grabbers.

Are the pins that go through the air grabber door flush on each side(where the decals are)? Or do they stick out the thickness of the head of the pin. If they are flush I have yet another modification to do.

thanks,

Dennis

Posted: **Wed Jun 20, 2007 9:04 am**

Not really even "flush", more like countersunk a bit so the decal can cover the holes.

Posted: **Thu Oct 25, 2007 5:28 pm**

Talking about these studs in the AG door, is the only thing holding them in place the decal? I havn't placed the new decals on the AG door yet and the studs tend to move out just enough to conflict with the bubble resulting in the door not opening!

Thanks,
Capsule

Posted: **Thu Oct 25, 2007 7:24 pm**

The head on the pin is below the the decal surface. The thing that holds it there is a "C" clip on the inside where the pin comes through. The pin has a groove for the "C" clip.

Posted: **Fri Oct 26, 2007 3:24 am**

Thanks Road Chicken!

I'll have to check if there's a groove for a c-clip in my pins.

Capsule

Posted: **Sat Oct 27, 2007 3:20 pm**

road chicken wrote:The head on the pin is below the the decal surface. The thing that holds it there is a "C" clip on the inside where the pin comes through. The pin has a groove for the "C" clip.

Exactly.

Posted: **Sun Oct 28, 2007 7:22 pm**

Capsule wrote:Thanks Road Chicken!

I'll have to check if there's a groove for a c-clip in my pins.

Capsule

no problem.