Repro wheel opening mouldings.........opinion?

ryangtogtx · Post by **ryangtogtx** » Sun May 06, 2007 11:35 am

Has anyone used the repro wheel opening mouldings available? If so what type of fit and general opinion. Thanks.

Post by **Eric** » Sun May 06, 2007 12:57 pm

I wasn't especially impressed with the quality of the Lasons repops....

ryangtogtx · Post by **ryangtogtx** » Sun May 06, 2007 2:32 pm

Specifically, has anyone purchased from this seller on ebay?

http://cgi.ebay.com/ebaymotors/1971-197 ... dZViewItem

mopar71 · Post by **mopar71** » Sun May 06, 2007 11:00 pm

That guy has been selling them on ebay for a while,I always have him on my watch list but I havent seen anybody bitting. I want to buy some good repops to but I thought laysons had the better ones? Eric I thought you liked the way they looked on your car

fourforty6pac · Post by **fourforty6pac** » Mon May 07, 2007 12:23 am

Ive been looking at them too. I'll wait because thats one of the last things I'll need to put on my car. Too bad they didnt put them on all the b body plymouths they would be eaiser to find and a little cheaper. They sure finish off a car nice not to mention they protect too. If he would start them out at $100 and see where it goes. I always seem to get alot more bids if I start something of at a low price. If your selling some desirable you will always get a fair price as long as you are not selling some crap.

Post by **Eric** » Mon May 07, 2007 12:43 pm

I like the way they look on the car, but I wasn't impressed with the quality. If it was a show car, I'd be embarassed....
Lots of scrapes, wrong bends, and misplaced holes