Sheetmetal on 4 speed bench car

general · Post by **general** » Mon Nov 12, 2007 9:11 am

Does anyone have pictures of what the hump area of a 4 speed/bench car should look like underneath. I posted what I have to deal with but I would like pictures of what it should look like. The prior owner changed the floor pan under the drivers feet and also cut up into the 4 speed hump. Any information would be appreciated.
Thanks Norm

moparmodeler · Post by **moparmodeler** » Tue Nov 13, 2007 8:43 am

I wish I could help. If the floor pan was copped up bad enough you may hve to replce a part of it befor you can add the hump. Scan the Mopar Muscle web sight I think the did an artical on a 71, 71 B-body four speed convesion.

general · Post by **general** » Sun Nov 18, 2007 9:21 pm

Well I guess no one has a car under construction that could take a picture. Any ideas where I can go and find this information out.

ajcpaperboy · Post by **ajcpaperboy** » Mon Nov 19, 2007 5:15 pm

This is of my 3 speed bench 71 road runner I hope it might help

ajcpaperboy · Post by **ajcpaperboy** » Mon Nov 19, 2007 5:18 pm

These were my only 2 shots

Road Runner Nest

Sheetmetal on 4 speed bench car

Sheetmetal on 4 speed bench car

Ick