bulge hood alignment
Moderator: Site Administrators
-
Serious Satellite
- GTX (RS)
- Posts: 559
- Joined: Mon Jan 22, 2007 11:44 pm
- My Cars: 1973 Plymouth Roadrunner (R.I.P.) totalled by my younger brother
1974 Plymouth Satellite Coupe (R.I.P.) sold to my other brother, died an ignoble death
1974 Plymouth Satellite Sebring (Rusted In Place) sent to crusher
1984 Dodge Ram Prospector D250, 360 ci engine, hooker headers, edelbrock 4 barrel carb, 1991 grill replacement - Location: Warsaw, Indiana and Dayton, Ohio...
bulge hood alignment
Okay, I've got the gap on the front valance even and it ligns up to the rear of both fenders well, but it's a bit off on the fender sides. The passenger side gap is about 1/3 wider than the driver's side. Is it a simple matter of loosening the hood hinge bolts on the drivers side and torqueing the passenger's side hood hinge bolts to pull the hood to that side of the car?
-
Smellslike1974
- GTX (RS)
- Posts: 2024
- Joined: Wed Nov 14, 2007 9:12 am
- Location: south new jersey
Re: bulge hood alignment
If the rear of both fender are aligned with the cars body,and the rear of the hood is aligned with the rear of the fenders,i would say either the header panel is un-aligned or the front of the fenders need shifting.
"Sunny D"-1974 Plymouth Satellite Sebring With Sundance Packaging
Re: bulge hood alignment
These directions work very good. http://www.restorick.com/tech/topic.asp?TOPIC_ID=10
-
Serious Satellite
- GTX (RS)
- Posts: 559
- Joined: Mon Jan 22, 2007 11:44 pm
- My Cars: 1973 Plymouth Roadrunner (R.I.P.) totalled by my younger brother
1974 Plymouth Satellite Coupe (R.I.P.) sold to my other brother, died an ignoble death
1974 Plymouth Satellite Sebring (Rusted In Place) sent to crusher
1984 Dodge Ram Prospector D250, 360 ci engine, hooker headers, edelbrock 4 barrel carb, 1991 grill replacement - Location: Warsaw, Indiana and Dayton, Ohio...
Re: bulge hood alignment
yes they do!73X wrote:These directions work very good. http://www.restorick.com/tech/topic.asp?TOPIC_ID=10
