





Moderator: Site Administrators
Just in case you're not kidding. right click on the picture and choose "view image" for the full picture. AND Thanks. Shes got just a little attitude about her.71Satellite98661 wrote:There is something to be said about clipping a photo to draw the eye but I've got to ask...were all of these intentional?![]()
71Satellite98661 wrote: By the way, those spoilers on a black car are 10x as cool as a colored car
I used Autometer Competition series, 2 3/4" with the cups and mounting brackets. I will get pictures of the installation tomorrow after the football game. but basically I made aluminum plates the size of the base of the cup mount, drilled holes to match in the plates. Then made a sandwich of Cup base- thick foam, hood-( no holes lined up with the vent louvers)- thick foam- aluminum plate. and bolted the whole thing together. I had to tighten it more than I thought to stop them from vibrating. It works great and the foam protects the hood paint very well. Here is a pic. Excuse the dust and crappy paint job.Ronnman wrote:Nice touch. Looks great. What gauges did you use, what size? Any pics of them and the way you mounted them?
Ron
The car did not have these from the factory. These are also early reproductions in fiberglass and not very good at that, but it's what was available at the time. They are not located as the dealership would/should have installed them. I laid them flat and the factory would have them going up at an angle so the end close to where the body line turns up to form the wheel well. Look on the net there are plenty of pictures and you'll see it right away. As for fitting them, low adhesive masking tape is your best friend. You can play with it until you get the position right before committing to drilling holes. Someone here may even have posted the factory locating diagram, since I'm sure this is a common question. I'm going to work on a full width spoiler with a little more depth, a short splitter, and a little wider to cover the front tires. That ought to really clean it up at speed.71Satellite98661 wrote:LOL!Your Photobucket photos are great! I didn't even try clicking on them.
Good to know about the spoilers. The boomerrangs; did that car have them originally? I've always wondered if it would be tricky to properly locate them on the valance w/o factory holes.
24" to the top of the wheel well opening. Stock is 27 in front. Rear is stock height. I have to be very slow when turning coming off a curb of the tires catch the wheel well trim. But once on level ground no problems. I Used Magnum force tubular upper arms and set it for -1 degree camber and +7 caster. Yeah is does give it a low stance. I have the satellite rocker trim that will go on for the final version. That ought to magnify the efFect even moredangina wrote:I love how low it sits!!!