Road Runner Nest

Agree to replace the rubber lines. They go up to a canister and 1 line to the breather. Don't block them off.

The dash harness can be temporarily bypassed, connect the alternator output lead(Black-12ga) to the battery positive, provide +12V to the engine harness ignition run circuit, dark blue wire with a trace. If needed, providing +12V to the brown wire while cranking will by-pass the ballast resistor, a...

So... I don't have my 71 SSP fully wired yet. I do have the following. 1. Engine bay harness installed 2. Direct battery wired run switch and push button starter (like on a run stand) 3. Voltage regulator mounted on the firewall My questions is this: What connections do I need to make so that the al...

Thanks. That was my guess, but wanted to verify.

1971 Plymouth SSP. Manual disc brakes. When attaching the MC pushrod to the pedel..

1. Which side is the rod on, compared to the pedal... Driver or Passenger?
2. Which side does the bolt go through... Driver or Passenger?


Need those questions answered or pictures.

Thanks.

Will a P/S floor shift steering column out of a 1973 Satellite work in a 1971 Satellite?

I know in 73/74 the k-member underwent some changes. Would that affect the steering column interchange?


Thanks.

I was wondering if maybe a punch and a C-Clamp. Want to loan me your tool?

So I've already changed my 1971 Plymouth SSP 318/auto from a column shift to a floor/slap stick shift at least from a transmission perspective. I have the parts to change the column itself over. In reading the FSM it seems there are 2 tools I should be using C-4044/Steering Shaft Remover and C-4113/...

Could be pinstriping tape effects.

Been over a year.. Any update on the house, garage ... Car?

Rockingham, NC Dragway. Saturday April 2nd. Drag racing, swap meet and car show.

I'll see you there!

http://www.rockinghamdragway.com/2016/m ... -the-rock/

Look at some of the older Stewart Warner gauges.

Now that I have widened the lower mounting tabs, the radiator is bottoming out on the lower radiator support before the top slots line up with the upper mounting holes.

Anyone else had this many problems with a Champion EC 374?

I pulled the trigger on a Champion EC374, 2 row, 26" aluminum radiator.

The bottom mounting tabs should be 28" on center, but it's 27.5". Guess I'll have to break out the jigsaw and widen the openings.

Patrick

It's the exact same one I have in my 71 Charger.. same 4 side vents. CR10A

I'll crawl under my Satellite tonight when I get home.