Road Runner Nest

If you want you can send the pics to me and I can toss them up on a host.

I see. Was gonna use them to help with my winter project.

Ack. Pics are gone. Was gonna nab a copy since my Stinger Fiberglass parts arrived yesterday.

Ok, looking for a place to get replacement bolts for trans to engine, engine mount bolts, starter to engine, etc.

Any suggestions?

1972RM23 wrote:i have pictures and measurement from my 72 RR.
I can post them later.

THat would prove quite useful as I have a roof strobe stripe kit also for mine and need to know where exactly to apply it.

I just finished cutting my hood today. Tomorrow starts with studs in the air grabber bubble and air door. I have a diagram from stinger, that helped me make all the right cuts on the hood, it was much easier than I thought it would be. I can give anyone that is interested the dimensions, or I can s...

If any of you can put together a word document or something with pics as a walk-through I can convert it to a web page and get it online.

I will eventually be doing this also so could use the info.

Check with 71440 gtx You need a complete air grabber switch, with hoses, vaccuum canister that goes on the pas. side inner fender, the hood activator and the bracket that holds it into place and the round plastic clips that hold the hoses in place. You will need to cut the hole in the firewall for t...

You need a complete air grabber switch, with hoses, vaccuum canister that goes on the pas. side inner fender, the hood activator and the bracket that holds it into place and the round plastic clips that hold the hoses in place. You will need to cut the hole in the firewall for the hoses to go throu...

So... where can I get a replacement timing cover for a '72 2-bbl 318?

I think someone needs their account removed...

http://www.roadrunnernest.com/Forum/sea ... =headboard

Were these a factory option? I have never seen these before...

I am bending mild steel tubing for replacement trans cooler lines to the radiator for my 72 sat w/ 904 at. Anyone know the length of tubing I will need for 1 line?

Ok, it seems the oil dipstick tube has broken off at the block on my '72 318. Is this something that can be replaced or will something need to be fabricated?

All I know is that its a 8 1/4" Dana Posi Unit (Clutch Type), part # 75101X, that fits 27 Spline Axles. supposedly for 96 and later dodge, chrysler, and plymouth...