Road Runner Nest

Thanks Dave. I was afraid to strong arm it without being sure, it's off and replaced now. Thanks Again

It has been far too long since I have had to do this. Is there a trick to getting the speedo cable disconnected from the tranny? It unscrews without issue, just can't pull the cable out.

Slotted wheels look good, I had them for quite some time on this car but then switched over to the Keystones. Not a great picture here but this is the SSP with slots. Face it - these cars are timeless, most anything looks great on them!

I'm running Keystones on mine (15"). While I love the style and always have - I'm not impressed with the quality! Today's wheels tend to rust easily.

Picture must have been too large - here is the photo intended to be in the last post.

Not sure if this helps or not. This assembly came off of a '72. I blasted & painted it. Ordered all new hardware for a '72 and the adjuster screws didn't work. The "shoulder" (not the head) on the '72 adjuster screws was just a bit too thick. They were replaced with what I was told was correct for a...

I put in the kit from PST. No issues other than discovering I needed to replace a lower control arm as well. I also used PST for my son's Duster - no issues there either.

The fuse would be in the main fuse panel behind the accelerator pedal. Try pulling out the ashtray and take a look at the cigarette lighter though. It would be one slide on connector with 2 wires feeding it. One wire is power from the fuse box to the lighter - and the other is power feed from there ...

Guys, I went to the roundup. Pictures just don't do justice to this GTX! WOW!!!!

You were correct, you muust have the key. I did find one for it. You have to slide each of the keyed tumblers in line with the cylinder as you pull to get it apart (one at a time). Thanks for the help.

I was afraid it was similar to an ignition switch removal. I'm going to have to start digging through boxes and see if I kept the trunk lock - I'm thinking this is also where a key might be .................. I hope !!!! Thanks for the information.

News is now saying rain for the weekend - still going?

Are you showing your car? What time will you be up there? I have followed the work you've done to it and would love to see it. You have to be proud - it is absolutely perfect!

Another one that should be simple, but apparently isn't for me. How do you remove the lock from the glove box door? I'm trying to get a dash frame and peripherals ready to send out for blasting - this is the last piece. Thanks.

I was up there for Cruizn' Colby last weekend, mopars were few and far between. I will probably go up to check out the swap meet but doubt I will take the SSP. I don't much care for people pawing all over the cars anymore.